1/24 Gawley Sketchbook TIE

moffeaton

Master Member
RPF PREMIUM MEMBER
For my next trick...

IMG_4286 2.jpeg
IMG_4285 2.jpeg
 
Jason are you printing from Rhino files, scratching or both? I keep waiting on pulling the trigger on a FormZ (which I seem to recall you have, or access to), but I have been 3D modeling for 20 years and every time I buy a kit now I end up making something for it and thinking, " I should have just built and printed the whole damn thing". Not to mention subjects not readily available, as you illustrate.
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top