clonus
New Member
Trying to make an "*******" costume from "Spaceballs" out of an acrylic light sphere. However, the corners of the piece I cut out for the face is causing cracks (see photo).
Wondering if there is some kind of spray or similar that could strengthen it? Would need to be paintable or gloss white if on the outside (or could just spray the inside). Would Plasti-dip, mod podge or similar work? Other thought was some fiberglass and resin around the inside of the helmet on the edge of the cut out to give it added strength but wonder if that would just cause cracking further up where the fiberglass would end?
Thanks!
Wondering if there is some kind of spray or similar that could strengthen it? Would need to be paintable or gloss white if on the outside (or could just spray the inside). Would Plasti-dip, mod podge or similar work? Other thought was some fiberglass and resin around the inside of the helmet on the edge of the cut out to give it added strength but wonder if that would just cause cracking further up where the fiberglass would end?
Thanks!