Fun with Polyfoam

Thread starter BLAST
Start date Jul 18, 2006

BLAST

Well-Known Member

Jul 18, 2006

So I've got a mold and I'm using a thin layer of latex, and I need to back it with polyfoam. When do I add the polyfoam? Do I brush it on AFTER the latex has completely dried and shrank? Or do I brush it on before it's set and shrunk?

Thanks.

This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.