Han in Carbonite LEGO USB drive

blownhemi

Well-Known Member
Got bored...

Han001.jpg

Han002.jpg

Han003.jpg

Han004.jpg

Han005.jpg


It's not the cleanest, and the Han was a smidge too short, but for 15 minutes work, I'm not complaining. Plus, the kids love it.
 
Thanks! I got bored and found him in the giant bucket of LEGO that the kids have. I popped a small flash drive I had laying around open and it was just about small enough. A quick couple of cuts on the scroll saw and a little Dremel work and it was done.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top