question on casting

Thread starter EdgeofNowhere
Start date Apr 6, 2006

EdgeofNowhere

Well-Known Member

Apr 6, 2006

I have some of these, and the flimsy quality of the plastic sorta bothers me. I was wondering if anyone had tried making resin casts of these before, and if there were any tips or tricks I should pay attention to.

thanks.
Jason

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.