Replacement docking rings? Deagostini M.Falcon

[Carnet]

Having a bit of a fitment issue with my docking rings, and during the process of correcting it I've managed to booger up one of my docking rings. It's not terrible, but I'll see it every time I look at it.

Does anyone know if anyone out there has designed some replacements?

 

[Ktaylor]

I might have a solution if you are up for rebuilding them and dealing with resin, I molded my base rings and plating and pulled a hand rolled hollow cast of it pretty well

 

[Ktaylor]

It has some of the issues you face when dealing with resin though such as potential little bubbles to fill since it’s hand rolled to be hollow I can’t pressure cast it, I can solid cast it in the tank for no bubbles but it will be much heavier.

There is also an area that has a little warp on the edge bit with resin it’s pretty easy to warm up and reshape.

 

[Ktaylor]

Can see the little bulge here, it’s subtle and should bend out pretty easy with a hair dryer or warm water.