There are a few left over, will be putting a small batch on my Etsy store in the near future!
-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Limited Run 2nd Run of Accurate RotJ Force Pike - Weapon of the Emperor's Royal Guard
There are a few left over, will be putting a small batch on my Etsy store in the near future!
Chucklaz
New Member
hey Tom - if you are going to sell these through Etsy, can you give those of us who replied early and said we were interested a heads up?
Good point! Looks like I can't publish the listing covertly or anything, so this will have to serve as the heads up:
I will be publishing the listing later today in my store here: TheProplicator - Etsy
Chucklaz
New Member
*starts hitting refresh on the store page*
Listing is live:
www.etsy.com
Rotj Force Pike Weapon of the Emperor's Royal Guard - Etsy
This Costume Weapons item by TheProplicator has 75 favorites from Etsy shoppers. Ships from Sandusky, OH. Listed on Aug 6, 2024
www.etsy.com
Chucklaz
New Member
ordered - looks like 9 left!Listing is live:
Rotj Force Pike Weapon of the Emperor's Royal Guard - Etsy
This Costume Weapons item by TheProplicator has 75 favorites from Etsy shoppers. Ships from Sandusky, OH. Listed on Aug 6, 2024
I've added a few more to that listing 
In other news I have been playing around with the kind of hard rubber used for prop guns and had an idea:
As any of you with one of these knows, that steel hob cutter is *sharp*, I've been considering doing a "con-safe" hard rubber version like in the video above that would be a straight swap (same threading) for the real steel one. I have yet to test cold casting it with steel dust but I'm fairly confident it'd work
Is this something any of you would be interested in?
In other news I have been playing around with the kind of hard rubber used for prop guns and had an idea:
As any of you with one of these knows, that steel hob cutter is *sharp*, I've been considering doing a "con-safe" hard rubber version like in the video above that would be a straight swap (same threading) for the real steel one. I have yet to test cold casting it with steel dust but I'm fairly confident it'd work
Is this something any of you would be interested in?
