smoothrat
Well-Known Member
WIP shots for my Bronn costume. Started for Dragoncon 2014, but actually finished in time for Dragoncon 2015. 
Here's what I'm going for.

Started with some accessories. Made a drinking horn from PVC pipe, with a wooden base. It's sealed and actually holds ale.


For the sword, I made a non-functional scabbard/hilt combo. The scabbard was carved from a board, and the handle is a 1" dowel. For the cross-guard, I used sintra for each side and then filled the center with epoxy putty. The pommel was modeled in 3D and printed. Finally the scabbard was covered in leather (cut from the sleeves of a thift-shop jacket), and the end chape cobbled together from craft foam.




The pommel model is now on Thingiverse: http://www.thingiverse.com/thing:662312
More to come...
Here's what I'm going for.

Started with some accessories. Made a drinking horn from PVC pipe, with a wooden base. It's sealed and actually holds ale.


For the sword, I made a non-functional scabbard/hilt combo. The scabbard was carved from a board, and the handle is a 1" dowel. For the cross-guard, I used sintra for each side and then filled the center with epoxy putty. The pommel was modeled in 3D and printed. Finally the scabbard was covered in leather (cut from the sleeves of a thift-shop jacket), and the end chape cobbled together from craft foam.




The pommel model is now on Thingiverse: http://www.thingiverse.com/thing:662312
More to come...
Last edited: