Ironman Mark 1 Back Relay Help

Thread starter Jason_E
Start date Feb 22, 2011

Jason_E

Well-Known Member

RPF PREMIUM MEMBER

Feb 22, 2011

Hello All,

I am hoping someone has a good close up picture of the yellowish relay that can be seen in the enclosed picture to the upper left of the propane tank.

It seems to have some call numbers on it that I just can't make out and would like to source the appropriate model for the Mark 1 back mechanics I am building. The one I currently have is too small based on the scale from the tank.

http://www.therpf.com/f9/ironman-mk-1-1st-test-vid-post-23-a-106596/

Any CSI style help is greatly appreciated.

Thanks in advance

Jason

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.