sharkmark VI helmet question

Thread starter freezen2001
Start date Apr 7, 2011

freezen2001

New Member

Apr 7, 2011

after finding out the hard way on a clonetrooper pep file i wanted to make sure that; on the mark VI helmet unless i have an unusually large head (which is not the case) i do not need to resize anything... is that correct? i looks as if it will be about 7.5 inches wide... which i assume is the outside of the helmet? so how big does that make the actual space you have to fit around your head?

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.