Transformers

Jedifyfe

Master Member
RPF PREMIUM MEMBER
Maggie Madsen ID:

TransformerMaggieBadge.jpg
 
Just wondering if anyone would like to take a stab at the Sector 7 ID badge from Transformers. Here are a few shots I found,

simmonsbadge.jpg


simmonsbadge2.jpg
 
does anyone recognize what was used to make the base of the gun in the pic? reminds me of an electric weed eater handle.

thomas;)
 
Last edited:
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top