Buildup AT-ST ROTJ (INSTRUCTIONS ADDED!)
- Thread starter EchoLeader
- Start date
shrugger
Well-Known Member
You funny, with your red X's and your none existant photo pages.:lol
If I understand correctly. I believe the droids your looking for can be
found on page 5
http://www.blockheadpictures.com/backlotstudios/ROTJ AT-ST Instructions.pdf
If I understand correctly. I believe the droids your looking for can be
found on page 5
http://www.blockheadpictures.com/backlotstudios/ROTJ AT-ST Instructions.pdf
Less than Super Ostrich
Well-Known Member
Nope. These parts are not on the instructions. I'm wondering what to put in the back (if anything) if you choose option 1 for the rear panel. Or is it just that big open space. And there are some parts that apparently go under the head and attach to the gun, but are not pictured in the instructions. Finally, there are two round pieces that I have no idea where they go (perhaps some caps for the leg joints).
try this link
http://i29.photobucket.com/albums/c269/bbeargie/AT-ST walker/atstparts.jpg
Less than Super Ostrich
Well-Known Member
Steve sent a couple picks of the back if you put in Option 2, but what if you don't. Is there a big hole back there then? And where do those two round pieces go? On the inside of one of the legs?
shrugger
Well-Known Member
The two large ones with the clips go inside the legs at the rearward facing
"Knee's". If you have the DVD, they can be clearly seen as on walks by.
Altough the Maths Studio model pic shows a flat tip bolt with a blind nut used at the ankle joints this is where I'll be using the 4 medium disks. I'll
leave the foot joints open showing the brass tubes.
The small disks can be used for the remaining joints if you wish.
The Allen bolt heads are obviously replacements in case of casting flaws.
(Of which, I haven't recieved any in my kit!:unsure)
I think we know where the big block goes.
Now, I have to admit. I'm somewhat stumped myself as to where those
bits of tube go. :confused
"Knee's". If you have the DVD, they can be clearly seen as on walks by.
Altough the Maths Studio model pic shows a flat tip bolt with a blind nut used at the ankle joints this is where I'll be using the 4 medium disks. I'll
leave the foot joints open showing the brass tubes.
The small disks can be used for the remaining joints if you wish.
The Allen bolt heads are obviously replacements in case of casting flaws.
(Of which, I haven't recieved any in my kit!:unsure)
I think we know where the big block goes.
Now, I have to admit. I'm somewhat stumped myself as to where those
bits of tube go. :confused
Last edited by a moderator:
Less than Super Ostrich
Well-Known Member
Last edited by a moderator:
shrugger
Well-Known Member
No. As it obviously wouldn't fit with the cover plate and Koolshade in place.
Less than Super Ostrich
Well-Known Member
I assumed so, but I thought perhaps you would cut it off about half way. It just looks rather odd with that big hole with no detail back there. Perhaps I will greeblie it up for my own edification. I'm only part purist!
