Star Wars Darth Vader ANH V2 Lightsaber replica

Sold for 480 USD
I made this from the most accurate parts I could find.

Main flash is a Larbel. I've chosen it because of the correct small B port, great chroming and overall nice quality.
Shroud is from Wanna Wanga
Grips are either also Wanna Wanga or Todd's costumes (I can't remember anymore which ones I used I think they are both equally good)
The bulb contact (emitter) is a real, functioning vintage part from a Heiland Flash that is practically identical to MPP's part.
Clamp card is Slothfurnace , populated with accurate vintage red LEDs , same as the small run I did few months ago.

Shipping costs are not included in the price. Please contact me for shipping options.

1709070796734.png

1709070826102.png

1709070861945.png

1709070918405.png

1709070962531.png

1709071702844.png


1709071003088.png
1709071036774.png
 
Last edited:
Did you sand the grips at all to make them flush?
Do you mean for the end cap step? I don't remember ... I've done that on some builds, but on this one I think I just used thicker double sided tape to compensate
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top