Kylo Ren Lightsaber Size?

[Kenzie C01]

I’m working on modifying this 3D model I found to be close to screen accurate. I printed off one of the parts and it seems tiny. It matches this blueprint I found, but take out a ruler and look: 9” does not seem right...

So what should the proper hight be? I can scale the parts when I find out. (Disney store and blade builders for comparison)

Sent from my iPhone using Tapatalk

 

[ARKM]

Most likely it's about a hair under 11-3/8" long. This is going by other measurements and blueprints people have provided for the official licensed version (not the FX version but the one that was around $1200 or so from that one prop company in England that went out of business) Oh and that blueprint in the pic you posted is very inaccurate. Below is a link to a post in this thread that has a pic that shows what the saber should look like (the one on the right)...

https://www.therpf.com/showthread.php?t=253984&page=26&p=4107433&viewfull=1#post4107433

I hope that helps.

 

[Kenzie C01]

Most likely it's about a hair under 11-3/8" long. This is going by other measurements and blueprints people have provided for the official licensed version (not the FX version but the one that was around $1200 or so from that one prop company in England that went out of business) Oh and that blueprint in the pic you posted is very inaccurate. Below is a link to a post in this thread that has a pic that shows what the saber should look like (the one on the right)...

https://www.therpf.com/showthread.php?t=253984&page=26&p=4107433&viewfull=1#post4107433

I hope that helps.

Thanks so much!


Sent from my iPhone using Tapatalk