lukyanov
Sr Member
It is in the final stages
-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
«SQUID» Sol's lightsaber from "Acolyte" replica (by Lukyanov) [pre-orders]
- Thread starter lukyanov
- Start date
lukyanov
Sr Member
I'll have maybe 3 extra sabers (there are clients who have stopped communicating or refused to pay)I'd love to take anyone's spot on the run or any extra hilt that may be available
Please let me know Lukyanov- love your work!
GMB1of12000
Well-Known Member
PM sent for the record
lukyanov
Sr Member
I guess no, the low value will be declared
No I don't think so! This is more akin to a piece of art then some sort of manufactured product.
lukyanov
Sr Member
Update: all of the "SQUID" sabers are ready to be shipped from the factory (I forgot about the Chinese New Year again, which caused a delay in the deadlines, plus some parts needed to be reworked a bit to make them as cool as possible).
They are all assembled and some of them will be shipped directly to my customers (for those who didn't ordered weathering or installing), the rest will be shipped to me, I hope to finish all my work until the end of March (but may be delayed because of shipping).
All of ordered chassis are ready in full too (assembled and tested). Regarding the board settings, I will contact you personally later.
A few pictures below.
Thanks for your support and patience
They are all assembled and some of them will be shipped directly to my customers (for those who didn't ordered weathering or installing), the rest will be shipped to me, I hope to finish all my work until the end of March (but may be delayed because of shipping).
All of ordered chassis are ready in full too (assembled and tested). Regarding the board settings, I will contact you personally later.
A few pictures below.
Thanks for your support and patience
Last edited:
Amazing news! this is my most anticipated saber project this year. Any update as to when the factory will ship the finished units to those of us that ordered no weathering or install?
lukyanov
Sr Member
Hey. Are you from the US? It will be shipped to the US during two days as a small batch and then it will be shipped to my customers from my friend inside of the US who will help me.
Yes I am in the US! Thanks for breaking it down, I was just curious about how to expect shipping information.
lukyanov
Sr Member
I'll write emails later
lukyanov
Sr Member
Low Profile NPXL V3/V4 10 Pin PCB Chassis Lens Cover
Here is the ShtokCustomWorx Low Profile NPXL V3/V4 10 Pin PCB Chassis Lens Cover. This is the lens diffusion cover for specific chassis designs which require a much lower profile lens cover where the chassis itself holds the PCB. Machined from acrylic. It is not compatible with any third-party...
thesaberarmory.com
For anyone doing their own install, here is my wiring diagram for my install. This is specific to my build and preferences when it comes to installs, but I figured this could cut some of the leg work out of designing the install for some folks. This is using a Proffie 3.9 but the wiring would be pretty much identical for a 2.2 install, only thing different would be some of the pad positions. Enjoy, y'all.
Similar threads
Done / Completed
Clan Saber Series #3: Ki-Adi-Mundi - Aayla Secura
