NS4
Well-Known Member
Thank you very much Adinelt.
Due to the resolution of the reference images, it was sometimes difficult to line up the crisp CAD lines of the model with the pixels of the references and any difference was only apparent once the physical model was finished.
As I noted in my previos post, these have all been corrected in the digital model (and were all less than 1mm).
I plan to go in and do a touch more to the weathering too before adding a sealing coat - as you have noted, it could do with being a little heavier in a few places. Again, this is much easier in hindsight with the comparison photos to use as a guide!
Not sure what the next project will be - I''ll definitely post it up on here when I do though!
Due to the resolution of the reference images, it was sometimes difficult to line up the crisp CAD lines of the model with the pixels of the references and any difference was only apparent once the physical model was finished.
As I noted in my previos post, these have all been corrected in the digital model (and were all less than 1mm).
I plan to go in and do a touch more to the weathering too before adding a sealing coat - as you have noted, it could do with being a little heavier in a few places. Again, this is much easier in hindsight with the comparison photos to use as a guide!
Not sure what the next project will be - I''ll definitely post it up on here when I do though!