Studio Scale Snowspeeder 1:10 Scratchbuilt

Hi guys,
Still not ready but quite advanced...
The cabin (cockpit) must be adjusted, cockpit itself is not finalized, red markings are missing, flaps are not finalized and much more weathering is needed. Fortunately I found some time and leisure to reach this stage of my Snowspeeder now.
Best,
Mark

1.jpg


2.jpg


3.jpg


4.jpg


6.jpg


10.jpg


11.jpg


5.jpg


9.jpg
13.jpg


12.jpg


7.jpg
 
Your scratch-building skills are remarkable. You appear to have used minimal kit-bashing for the details; and instead, carved and built up the details by hand. Amazing!
 
Your scratch-building skills are remarkable. You appear to have used minimal kit-bashing for the details; and instead, carved and built up the details by hand. Amazing!
Thank you Duncanator! Yes, my models are almost completely scratchbuilt from styrene parts. Main reason was to keep the costs low and also to avoid a long searching for the right parts.
Best,
Mark
 
Absolutely superb!. Your scratch building skills are most admirable, crisp, clean & looks perfect to the filming miniatures!.
Pure joy to see come together!.

Stu
 
Absolutely superb!. Your scratch building skills are most admirable, crisp, clean & looks perfect to the filming miniatures!.
Pure joy to see come together!.
Thanks a lot Stu for this very friendly comment! I am pleased to read that you like my work with these Snowspeeders.
Best,
Mark
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top