This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Well, it’s the 6th. What’s the deelie, yo?
Sean
Thanks for putting this together, Roy - order is in!
Are those ECO Grips brand new also? I don't remember seeing them before and can't find a post here about them.
I was lucky enough to be able to get a kit pre-launch. It came in yesterday and I have done a dry fit. Here is a shot of the first fit. I have since drilled and tapped the holes (per the amazing instructions and blueprints) and everything is fitting together nicely now. Next week is sanding and priming. I can’t thank Roy enough for putting this kit out there.View attachment 1365724View attachment 1365725
Thanks Chris and you're welcome!
Will you be using the real wader's studs?
I think I might. I was thinking I would cut one of the split rivets off for easier installation and then secure with some superglue. I would be nervous trying to spread the rivet inside. My luck I would crack the resin.
I think I might. I was thinking I would cut one of the split rivets off for easier installation and then secure with some superglue. I would be nervous trying to spread the rivet inside. My luck I would crack the resin.
I am unclear on the diodes/vents? What do the the two options look like and their difference.